approved iso


How to adjust compressing pressure for SVBB2 series

 
Increasing or decreasing the compressing pressure will directly affect the density of your bale. Please follow the steps below to learn how to adjust compressing pressure on your baler. Remember to refer to the safety working pressure stated on your Operator Instruction Manual to ensure you don’t go above the limit.
 
Pressure Adjustment for Long Stroke Baler

Pressure adjustment steps for Long Stroke Baler:

1. Turn on the power and start the motor.

2. Adjust overflow valve (see B) by turning knob clockwise as per the red arrow during baling, you will see the pointer of electro-connecting pressure gauge (see A) increase during the process. Turning the knob anti-clockwise, you will see a decrease of pressure.

 

NOTE:
– Adjust the valve slowly to achieve higher pressure, check the pressure gauge at all time so as to not increase too much at one time.

– The recommended pressure has already been set at our factory before delivery. Therefore, do not make any adjustment to pressure unless it is necessary.